Hey Chucklefish :) Wiring question, and 3D printing?.

Yes. HOW did you do this? It's already impossible enough to accurately wire something with the wire squares being so close to each other and the actual place where you have to click being so far off from the square.

 

The zig-zag pattern we placed the gates in makes it possible for all the nodes to be clickable. Also we're VERY careful. If you do make a mistake we just go back to the node we started from and re-wire. Doesn't happen very often fortunately.

 

Well, wow, that is impressive. I had extreme trouble simply wiring doors right next to each other.

 

What are you trying to do if you mind me asking?

 

I was trying to have one door open a whole bunch of other doors just for fun, but I wasn't able to very successfully do it. Doors kept wiring to themselves.

 

Oh wow that's NICE!... mess you got there. xD Yeah I should, play around with the assets but I m a little lazy to do that, and I building stuff in the friends house on a planet we sat on.
Anyway good stuff.

 

Nice video, and good Circuit.